4-27
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
WID-3271 The value entered must be greater than {0}. The value entered must be greater than the
specified value.
WID-3272 An entry is required. An entry is required to complete this task.
WID-3273 {0} already exists in the list. The specified item already exists in the list.
WID-3274 A software upgrade is in progress.
Network configuration changes that result in a node reboot
cannot take place during a software upgrade.
Please try again after the software upgrade is done.
Refer to the warning message text.
WID-3275 Ensure that the remote interface ID and the local interface ID
on the two sides match.
(The local interface ID on this node should equal the remote
interface ID on the neighbor node and vice-versa).
Refer to the warning message text.
WID-3276 Both {0} and {1} exist on the same selected port.
{2}
The specified port has both SDCC and
LDCC.
WID-3277 The description cannot exceed {0} characters. Your input will
be truncated.
The input exceeds the character limit. The
value will be truncated to the maximum
chapter limit.
WID-3279 This card has been deleted. CTC will return to the shelf view. CTC returns to node view.
WID-3280 ALS will not engage until both the protected trunk ports detect
LOS.
Refer to the warning message text.
WID-3282 Performing a software upgrade while TSC 5 is active could
result in a service disruption. It is recommended that you make
TSC 10 the active TSC by performing a soft reset of TSC 5. The
following ONS 15600s are currently unsafe to upgrade...
Refer to the warning message text.
WID-3283 Before activating a new version, ensure that you have a
database backup from the current version.
Refer to the warning message text.
WID-3284 Reverting to an older version. CTC is being reverted to an older version of
application.
WID-3285 Applying FORCE or LOCKOUT operations might result in
traffic loss.
Refer to the warning message text.
WID-3286 The ring status is INCOMPLETE. CTC cannot determine if
there are existing protection operations or switches in other
parts of the ring. Applying a protection operation at this time
could cause a traffic outage. Please confirm that no other
protection operations or switches exist before continuing.
Refer to the warning message text.
WID-3287 There is a protection operation or protection switch present on
the ring. Applying this protection operation now will probably
cause a traffic outage.
Refer to the warning message text.
WID-3288 The status of this ring is INCOMPLETE. CTC will not be able
to apply this change to all of the nodes in the {0}.
Change the ring status to apply the change
to all nodes in the ring type.
EID-3290 The specified provisionable patchcord(s) could not be deleted. Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
