4-28
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3291 The revertive behavior cannot be changed because a protection
switch is active.
Protection switch should not be active to
change the revertive behavior.
EID-3292 An error occurred while resetting the shelf. CTC encountered an error while resetting
the node.
EID-3293 No such provisionable patchcords exists. You are attempting to delete a provisionable
patchcord that does not exist. This happens
when multiple instances of CTC are
running and attempting to delete the same
provisionable patchcord concurrently.
EID-3294 No RMON thresholds are available for the selected port. Refer to the error message text.
EID-3295 This card does not support RMON thresholds. Refer to the error message text.
EID-3296 Buffer-to-buffer credit is only supported for Fibre Channel (FC)
and FICON.
Refer to the error message text.
EID-3298 This interfaces does not support ALS auto restart. Refer to the error message text.
EID-3300 Duplicate OSPF area IDs are not permitted. OSPF area IDs should be unique.
EID-3301 The LAN metric cannot be zero. Refer to the error message text.
EID-3302 The standby {0} is not ready. Standby controller card is not ready.
EID-3303 The DCC area ID and {0} conflict.
{1}
DCC Area ID and ring type, specified by
{0}, conflict each other due to the details
specified by {1}.
EID-3304 The DCC number is out of range. Enter a DCC number that is within the range
EID-3305 OSPF cannot be active on the LAN interface when the
backbone area is set on a DCC interface.
You cannot have the default OSPF area on a
DCC while OSPF is enabled on the LAN.
EID-3306 Ethernet circuits must be bidirectional. Refer to the error message text.
EID-3307 An error occurred while creating a connection object at {0}. CTC encountered an error at the specified
connection while creating the connection.
EID-3308 DWDM links can be used only for optical channel circuits. Refer to the error message text.
EID-3309 The link was excluded because it was in the wrong direction. The optical channel (circuit) does not allow
the specified link to be included because it
is in the wrong optical direction.
EID-3310 The DWDM link does not have wavelengths available. Refer to the error message text.
EID-3311 The laser is already on. Refer to the error message text.
EID-3312 The power setpoint cannot be changed.
{0} {1}
CTC cannot change the power setpoint. The
new setpoint would either make the
thresholds inconsistent or set the fail
threshold outside the range.
EID-3313 The offset cannot be modified because the service state of the
port is IS.
Refer to the error message text.
EID-3314 The requested action is not allowed.
The state value is invalid.
Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
