4-31
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3376 The measured span loss could not be retrieved. Refer to the error message text.
EID-3377 The wrong interface was used. The interface used for the card is wrong.
EID-3378 This is a duplicate origination patchcord identifier. The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the origination node.
EID-3379 This is a duplicate termination patchcord identifier. The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the remote node.
EID-3380 The host cannot be found. Refer to the error message text.
EID-3381 The maximum frame size must be between {0} and {1} and
may be increased in increments of {2}.
The frame size must be in the specified
range. It can increment by the specified
value.
EID-3382 The number of credits must be between {0} and {1}. The number of credits must be between the
specified values.
EID-3383 The GFP buffers available must be between {0} and {1} and
may be increased in increments of {2}.
The GFP buffers must be in the specified
range. It can increment by the specified
value.
WID-3384 You are about to force the use of Secure Mode for this chassis.
You will not be able to undo this operation.
Is it OK to continue?
Refer to the warning message text.
EID-3385 {0}. Delete the circuits and try again. Refer to the error message text.
EID-3386 The transponder mode could not be provisioned:
{0}
The specified transponder mode cannot be
provisioned.
EID-3387 You must change port(s) {0} to an out-of-service state before
changing card parameters. Click “Reset” to revert the changes.
All the card ports should be changed to
out-of-service before changing the
parameters.
EID-3388 The card mode cannot be changed because the card has circuits. Refer to the error message text.
EID-3389 An error occurred while changing the card mode. Refer to the error message text.
EID-3390 The port is in use. Refer to the error message text.
EID-3391 The port rate cannot be changed because the port has been
deleted.
You cannot change the port rate of a card
that has been deleted.
WID-3392 The timing reference(s) could not be assigned because with
external timing, only a single protected, or two unprotected
timing references per BITS Out can be selected.
Please use the "Reset" button and verify the settings.
Refer to the warning message text.
WID-3393 The timing reference(s) could not be assigned because with line
or mixed timing, only a single unprotected timing reference per
BITS Out can be selected.
Please use the "Reset" button and verify the settings.
Refer to the warning message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
