4-32
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3394 An error occurred while refreshing the power monitoring
values.
Refer to the error message text.
EID-3395 The configuration is invalid.
{0}
CTC encountered an error in IP address, net
mask length, or default router, or a
restricted IIOP port was selected.
EID-3396 The configuration is invalid. The standby controller card is not
a TCC2P card.
The standby controller card should be a
TCC2P card.
EID-3397 The file {0} is the wrong version. The specified file is of wrong version.
EID-3398 The PPM cannot be deleted. Refer to the error message text.
EID-3399 The PPM cannot be deleted because it has port(s) in use. Remove the ports connected to the
Pluggable Port Module before it can be
deleted.
EID-3400 Unable to switch. A force to the primary facility is not allowed. Refer to the error message text.
EID-3401 {0} cannot be provisioned for the port while {1} is enabled. The relationship between parameters {0}
and {1} are such that enabling either one,
prevents the provisioning of the other.
EID-3402 The switch request could not be completed.
The {0} card is not present or is not responding.
Try again after ensuring that the {0} card is present and is not
resetting.
Refer to the error message text.
EID-3403 The administrative state transition has not been attempted on
the monitored port.
Refer to the error message text.
EID-3404 The far end IP address could not be set on the {0} termination.
The IP address cannot be:
loopback (127.0.0.0/8)
class D (224.0.0.0/4)
class E (240.0.0.0/4)
broadcast (255.255.255.255/32)
internal {1}
Refer to the error message text.
EID-3405 You cannot change card parameters with port {0} in {1} state.
Click "Reset" to revert the changes.
Refer to the error message text.
EID-4000 The {0} ring name cannot be changed now because a {0}
switch is active.
You cannot change the ring name because a
switch of the same ring type is active.
EID-4001 The {0} node ID cannot be changed now because a {0} switch
is active.
You cannot change the ring ID because a
switch of the same ring type is active.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
