4-33
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
WID-4002 CAUTION: Reverting to an earlier software release may result
in TRAFFIC LOSS and loss of connectivity to the node. It may
require onsite provisioning to recover.
If the node was running {0} before, reverting will restore the
{0} provisioning, losing any later provisioning. If the node was
running some other version, reverting will LOSE ALL
PROVISIONING.
{1}
{2}
Refer to the warning message text.
EID-4003 The Cisco IOS console is disabled for the card in Slot {0}. The card may not be an IOS-based card or it
may be rebooting.
EID-4004 An error occurred while canceling the software upgrade. CTC encountered an error while cancelling
the software upgrade.
EID-4005 {0} encountered while performing a database backup. CTC encountered the specified error during
database backup.
EID-4006 The file {0} does not exist or cannot be read. Refer to error message.
EID-4007 The size of the file {0} is zero. The size of the file that is being backed up
or restored is zero.
WID-4008 A software upgrade is in progress.
{0} cannot proceed during a software upgrade.
Please try again after the software upgrade has completed.
The specified action cannot be performed
during a software upgrade. You must try
after the upgrade process is completed.
EID-4009 {0} encountered while restoring the database. CTC encountered the specified error while
restoring the database.
EID-4010 The operation was terminated because:
{0}
Refer to the error message text.
EID-4011 An error occurred during provisioning:
{0}
Refer to the error message text.
EID-5000 A valid route cannot be found for the tunnel change request. Refer to the error message text.
EID-5001 The tunnel could not be changed. Refer to the error message text.
EID-5002 The tunnel could not be restored and must be recreated
manually.
Refer to the error message text.
EID-5003 The circuit roll failed.
{0}
Refer to the error message text.
EID-5004 There is already one four-fiber {0} provisioned on the set of
nodes involved in {1}. The maximum number of four-fiber {0}
rings has been reached for that node.
There is already one 4F BLSR provisioned
on the set of nodes involved in the ring. The
maximum number of 4F BLSR rings has
been reached for that node.
WID-5005 A non-zero hold-off time can violate switching time standards,
and should only be used for a circuit with multiple path
selectors.
Refer to the warning message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
