DEACTIVATION
EXECUTED
SCENARIO ↵ ↓
Scenario P1
OPENED ZONES! ↵
FORCE? ↓
10
Area deactivation
To deactivate the areas, enter the code and press 'OFF'; the following screen signals that the operation
has been completed successfully.
Partial activations P1 and P2
To activate partial scenario P1 or P2:
1. Enter the code then press the key associated with the desired scenario. The screen in the figure
illustrates what happens after P1 is pressed (the same thing will happen for P2).
2. Press ‘ENTER’ to confirm activation, or select a different scenario using the up and down arrow keys,
then press ‘ENTER’.
3. The keypad shows confirmation message “SCENARIO EXECUTED”.
IMPORTANT: the installer can program the P1 and P2 keys to activate scenarios other than partial 1
and 2, selecting other scenarios from the 16 programmable options.
Using the function keys
The function keys F1/F2/F3/F4 can be used to perform various actions, such as: total activation, total
deactivation, reset alarms, stop alarms.
To use them:
1. Enter the 6-digit code.
2. Press the function key associated with the desired action.
3. At this point the activation or command confirmation screen will appear.
When using the function keys, you do not need to press 'ENTER' to confirm the action after pressing the
function key itself.
IMPORTANT: to change the action associated with the key, contact your installer.
Quick activation
Quick activation is used to activate the system without entering the user code.
This type of activation is available for the following keys:
• ON: total activation
• P1, P2, F1, F2, F3, F4 : to perform the action associated with the key
To use it:
press and hold the key corresponding to the desired action for 2 seconds.
IMPORTANT: these activations which do not require the user code are applied to all areas for which the
keypad is enabled.
IMPORTANT: the use of quick keys can be enabled or disabled by the installer during programming.
Activation with zones open
If zones are open during system activation, before confirming the action the keypad will display:
Different methods can be used to continue with activation:
A. (recommended option) Cancel the operation by pressing 'C', close the open zone and retry
activation.
B. Force activation by pressing "ENTER". This method forces activation, generating a fault condition
To Next Page
Loading...
