20:41 09-11-2015 20:41 09-11-2015
U U U U U U U U
Output Time
< < < < < < < <
ACTIVATE
TOTAL?
ACTIVATION
IN PROGRESS
20:41 09-11-2015
S S S S S S S S
9
IMPORTANT: If an Exit time is set, the keypad will signal it by beeping (see "Buzzer" on page 8) for the
duration of the Exit time period.
Keypad procedures
Key sequence Operation
Code + ON +
Total activation
Code + OFF Deactivation
Code + P1 +
Partial 1 activation
Code + P2 +
Partial 2 activation
Code + ‘prog’ System management menu access
Code + function key Execution of the function associated with key F1/F2/F3/F4
Code +
Display last event in Alarm Log, if present. If there are no events recorded in the Alarm Log,
or if the alert has already been displayed, on pressing Enter, the message "FUNCTION NOT
AVAILABLE" will be displayed. It is however still possible to view previously displayed alerts in
Events Log (see complete User Manual).
Unauthenticated users can only use the delete key “C” or the numerical keys. If a key that is not
usable is pressed, the display will show the message "FUNCTION NOT AVAILABLE".
Authenticated users of the keypad who press button C will be returned through the previous menu
until the area status is displayed. If the value of the area status display time for that keypad is not
unlimited, the next press of button C will return the keypad to standby mode, with no indication of
the current status of the areas (immediately hiding the information on the display).
√ With device in standby.
or:
Enter the 6-digit user code followed by the keys corresponding to the required operation. The operations
available are listed below:
Total area activation
This procedure activates all areas enabled for the user and the keypad from which he/she is sending the command.
To carry out total activation:
1. Enter user code and press ‘ON’.
2. Press ‘ENTER’ to confirm activation, or ‘C’ to cancel.
3. If activation is confirmed the following screen will appear, if it is cancelled the display will revert to the
"System status display" see page 7screen.
4. If the operation was completed successfully, an ‘I’ will appear in correspondence with the activated
areas to indicate total activation of the area.
To Next Page
Loading...
