FAULTS ! ↵
FORCE? ↓
FAULT ↓
VoiceSyntFault
ACT. LOCKED
Press C to Esc
OPENED ZONES! ↵
FORCE? ↓
Kitchen Window
EXCLUDE? ↓
EXCLUDED ZONES!
ENTER? ↓
TOT ZONE LOCK
Press C to Esc
11
Activation in presence of faults
If faults are present during system activation, before confirming the action the keypad will display:
To continue with activation if a fault has been detected, you will need to force the procedure.
IMPORTANT: the user may not be authorised to force activation in the presence of certain faults; for
authorisation contact your installer.
From the previous screen (FAULTS! FORCE?):
Use the arrow
to view all faults.
Press "ENTER" to force activation.
If the user is not authorised for forced activation, the following screen will appear:
To exclude opened zones, proceed as follows:
2. To confirm exclusion of the zone you are viewing, press ‘ENTER’.
3. For activation to take place, ensure all open zones are excluded, then repeat the process
described in steps 1 and 2 for all open zones.
4. After the exclusion procedure has been completed for all open zones, the following screen will
appear:
√ From the following screen:
1. Press the arrow
to display the open zones
5. Press ‘ENTER’ to activate, or press 'C' to cancel.
6. If the operation is completed successfully, an ‘I’ will appear in correspondence with the activated
areas to indicate total activation of these areas.
If the exclusion procedure has not been performed for all open zones, the following screen will appear to
indicate that activation has not been carried out.
IMPORTANT: If an Exit time is set, the keypad will signal it by beeping (see "Buzzer" on page 8) for the
duration of the Exit time period.
for the open zones (to be used only when the zone cannot be closed, because it reduces the security
level of the system).
C. Exclude the zone. This method allows you to exclude the open zones from activation (to be used
only when the zone cannot be closed, because it reduces the security level of the system).
To Next Page
Loading...
