Options
Auth.Inst.Perm.
Activat.Param.
YES
Options
Timer
Timer ON/OFF:
----XXXX---------
27
Permanently enable installer
This option can be used to permanently enable or disable the installer code; in this mode installer enabling
does not expire after 4 hours.
Using the arrow keys, navigate to the screen "System Mgmt/Options/'Perm.Enable Inst." and press
'ENTER'.
At this point press the navigation keys to select whether to permanently enable the installer code or not,
then confirm using 'ENTER'.
» Completion of the procedure is confirmed by the message 'PARAMETER CHANGED'.
Enable/Disable timer
This option can be used to enable the timers for timed activation procedures.
Using the arrow keys, navigate to the screen "System Mgmt/Options/Timer"
Press 'ENTER' to access the timer enabling screen.
On the second line, each character represents one of the 16 timers, where '–' indicates disabled and 'X'
enabled.
To change the status of a timer, select it using the right and left arrow keys, then press 'ON' to enable
it (an 'X' will appear) and 'OFF' to disable it (a '–' will appear).
To Next Page
Loading...
