Comelit VEDO - Event Key 1 (or 2); Overtime; Stop Alarms; Reset Alarms

GENERATE
EVENT 1 KEY CMD?
GENERATE
OVERTIME CMD?
GENERATE
STOP ALARMS CMD?
GENERATE
RESET ALARM CMD?
GENERATE
STOP PHONE CALL?
19
Event key 1 (or 2)
This option generates the event configured for key 1 on the keypad.
The same applies for event key 2.
IMPORTANT: these commands can be associated to the function keys on the keypad to control
outputs or to generate telephone alerts (telephone calls or SMS).
Overtime
This option can be used to delay timed activation procedures.
The default delay time is 60 minutes, and 3 postpone requests can be made.
IMPORTANT: the delay time and the number of requests are parameters which can be changed by
the installer during programming.
IMPORTANT: if timed activations are not enabled, the request will still be completed successfully
even though it will have no effect.
Stop Alarms
This option generates a Stop alarms event. This allows the stoppage of a current alarm by deactivating any
active outputs (sirens, flashing lights, etc.) and blocking any telephone calls in progress or in the queue.
IMPORTANT: This command is implicitly carried out with each deactivation.
Reset Alarms
This command generates a Reset alarms event, which resets everything to do with the alarm condition.
Execution of the command leads to the resetting of alarm cycles, alarm conditions and alarm memory, and
ends any calls in progress.
IMPORTANT: This command is implicitly carried out with each activation.
Stop telephone calls
If the control unit has been programmed to make calls when certain events (alarms, tampering) occur, when
these conditions arise the control unit will call the programmed numbers.
This option can be used to block all calls in progress (including silent calls) and cancel any queued calls.