Comelit VEDO - Single Area Activation; Quick Alarms

Activations
Act. Single Area
ACTIVATE ↵ ↓
Area 1
ACT. TYPE ↵ ↓
TOTAL
System Mgmt.
Quick Alarms
ACTIVATE
BURGLAR ALARM?
ALARM
EXECUTED
17
Single area activation
This option can be used to activate a single area.
From the following screen:
 Press 'ENTER' to access the screen ACTIVATION/Area 1
 At this point, use the arrows (up and down) to select the area to be activated.
 Press ‘ENTER’ to activate an area.
 Now use the Up and Down arrows to select the type of activation (total, P1...) you wish to apply to the
area, then press 'ENTER' to activate the selected type.
IMPORTANT: the various activation types for a single area are also present with a variant without an
exit time. If you select: "TOTAL DEL. OFF" the area will be activated in TOTAL mode without any exit
time.
If the exit time has not been configured there is no difference between "TOTAL" and "TOTAL DEL. OFF
Quick Alarms
This option can be used to cause one of the following types of alarm event:
• Theft (Activate theft alarm?)
• H24 (Activate H24 alarm?)
• Fire (Activate fire alarm?)
• Panic (Activate panic alarm?)
• Burglary (Activate burglar alarm?)
• Flood (Activate flood alarm?)
• Gas (Activate gas alarm?)
• Doctor (Activate doctor alarm?)
Use the arrows to scroll through the user menu until you see:
 Press 'ENTER' to enter the sub-menu, then use the arrows to scroll through the alarm types, for
example:
 Press 'ENTER' to cause the selected alarm.