GENERATE
UNIT RESET CMD?
GENERATE
AUTH.INST.CMD?
GENERATE
AUTH. MANUF.CMD?
20
Reset control unit
This option can be used to cause a control unit reset.
This command is only available to authorised users.
IMPORTANT: standard users, by default, are not authorised to execute this command, which is
restricted to Installers.
Request support
Authorise Installer
Authorise manufacturer
Not implemented.
This option gives the user control unit access authorisation.
This option (only available for the installer) enablesthe manufacturer code. This operation is essential for
the purposes of system updating.
After execution of the command the installer remains authorised for 4 hours; once this time has elapsed the
authorisation command must be executed again.
After execution of the command, the manufacturer remains authorised for 4 hours; once this time has
elapsed the authorisation command must be repeated.
This option can be used to carry out one of the following commands:
IMPORTANT: remember that in order to access the control unit using his own code, the installer must
first be authorised by the user.
IMPORTANT: remember that in order to access the control unit using his own code, the manufacturer
must first be authorised by the installer.
Test
• Inputs Test
• Outputs/Siren test
• SIM test
• Generic ev. test
• MMS send test
• Radio RSSI test
• Digital dialler test
• Credit remaining
• GSM network level
To Next Page
Loading...
