73
(3) Outputs
This menu can be used to find out the status of a specific output or control it.
The menu consists of the following voice messages:
Then press the key corresponding to the desired action, followed by the output number.
(3.1) "Press One followed by output number for status"
(3.2)"Press Two followed by output number to activate it"
(3.3)"Press Three followed by output number to deactivate it"
(3.4)"Press Four followed by output number to toggle"
(4) Alarm log
There is no sub-menu for this option. The voice messages relating to the alarm log status for the
system or area will be played.
(5) Zones
This menu can be used to find out the status of a specific zone or control it.
The menu consists of the following voice messages:
(5.1) "Press One followed by zone number for status"
(5.2) "Press Two followed by zone number to include it"
(5.3) "Press Three followed by zone number to exclude it"
(5.4) "PressFour followed by zone number to activate it"
(5.5) "Press Five followed by zone number to deactivate it"
Then press the key corresponding to the desired action, followed by the output number.
SMS commands
The control unit can be managed by sending commands in a suitable format via SMS.
The available commands are:
Action Description
Alarms memory Returns alarm log status
Status Returns area status (as indicated on the keypad)
Activate Activates the alarm in the areas indicated
Forced activation Forces alarm activation the in the areas indicated
Deactivate Deactivates the alarm in the areas indicated
Zones Returns status of the zones indicated
Include zones Includes the zones indicated
Exclude zones Excludes the zones indicated
Activate zones Activates the zones indicated
Isolate zones Isolates the zones indicated
Outputs Reports status of the outputs indicated
Activate outputs Activates the outputs indicated, if present
Deactivate outputs Deactivates the outputs indicated, if present
Credit Requests the total credit remaining on the SIM
Stop alarm Sends the Stop alarm command
• code: user code you are applying
• command: the request or command you wish to issue
• attributes: if present, these are a further specification for the requested action, such as the list of areas
involved; they are separated from each other by a space
• reply: the reply following the required action
IMPORTANT: commands received by the control are not case-sensitive. Example: if you enter 'credit' or
'CREDIT', the end result will be the same.
» If the code is not valid, the control unit will not reply to this SMS.
» If the code is valid, but the command is missing or in the wrong format, the reply will be: ERROR
The commands are formatted as follows:
where the character '_' indicates a space.
The meaning of each field is as follows:
SMS command: code_command_attributes
SMS reply: action:_reply
To Next Page
Loading...
