Fault:
RadioCntrlBatt.
70
USING THE RADIO CONTROL
The main system functions can be managed remotely (within range of the control unit receiver) using the radio
controls as described in this paragraph.
The radio control has 4 buttons which can be used to carry out the desired action, plus 3 indicator LEDs.
Radio control indications
The radio control has three indicator LEDs, one at the top and two underneath buttons 2 and 3 respectively,
as illustrated in the figure.
The indications described in the table all consist of a single flash.
LED Description
1
One flash - Red
Command not implemented: radio control out of range of control unit
receiver
One flash - red, then one green Command being processed by the control unit. (Not yet executed).
2 One flash - red Command not executed (command processed but not executed)
3 One flash - red Action executed (confirms execution of all actions)
Actions via radio control
To operate the system using the radio control, press the key corresponding to the action you wish to carry
out.
The actions configured as default are:
• Key 1: Deactivation
• Key 2: Full activation
• Key 3: Partial 1
• Key 4: Medical emergency alarm
IMPORTANT: The actions associated with the buttons can be changed by the installer during system
programming.
Exhausted battery
The control unit signals an exhausted battery in a radio control through the illumination of the yellow LED
(number 2), while showing the following message on the display of the supervisor (keypad/Vedo Touch):
Alarm lock in progress
To stop an alarm in progress from a radio control, press the deactivation button (regardless of whether the
system is activated or deactivated); this will deactivate the system and stop the alarm.
To Next Page
Loading...
