Syst. Analysis
Fault-finding
SYSTEM OK
Press C to Esc
FAULTS! ↵
↓
TAMPER! ↵
↓
FAULTS! ↓
VoiceSyntFault
FAULTS! ↓
IP Fault
Error: ↓
Link
System Mgmt.
Syst. Analysis
24
Fault-finding
This option can be used to view any faults and/or tamper events.
» If no faults or tampering events are present, the following will appear:
Press 'ENTER' to launch the fault-finding procedure.
Press ‘ENTER’ to access the System Analysis menu.
» On the other hand, if there is a problem with the system, the type of problem is displayed (fault or
tampering).
or
To view additional information (if available) on the fault or tampering, press the down arrow; for example.
When all the faults have been viewed, press the down arrow to return to the 'FAULTS!' screen.
For some faults, additional details can be displayed by pressing the right arrow
. In the following example,
in the case of the fault "IP Fault", the additional information "Error: Link" is displayed, indicating that the IP
expansion network cable is disconnected.
If both faults and tampering are detected, the faults are displayed first, followed by the tampering events.
Press 'ENTER' on the 'FAULTS!' screen to move on to the 'TAMPER' screen.
Press 'C' to exit the menu.
Use the arrow keys to scroll through the System Mgmt. menu to display:
To Next Page
Loading...
