Compaq Armada 7800 - Registering the Phone with the Modem

Using the Internal Modem 7-15
Writer: Carey Gregg Saved by: Rebecca Wiggins Saved date: 02/06/98 11:07 AM
Part Number: 314932-001 File name: Ch07.doc
Registering the Phone with the Modem
NOTE:
Use Windows HyperTerminal to enter command mode and
register the phone with the modem.
If you want to use a cellular phone with the modem, use one of the
following commands to register or set up the cellular phone with
the modem.
■
$M1 if
you are using a Motorola, JVC, or Pioneer phone
.
■
$M2
if you are using a Nokia, Technophone, AT&T (selected
models), or Tandy phone
.
NOTE
:
$M3
is not supported by this modem
■
$M4
if you are using a GE or Ericsson phone
.
NOTE:
You can also access the $ command set through the
Online
Reference Guide.
Select the Commands menu at the top of any
modem screen.
This command needs to be issued only once; thereafter, the
modem checks for the presence of the cellular phone. If a cellular
phone is connected, the modem dials through the cellular phone;
otherwise, it uses a standard (RJ-11) telephone connector.
NOTE:
To modify this command, refer to “Using the &J Command
(Telephone Interface Control)” later in this chapter.