EasyManua.ls Logo

Compaq Armada 7800 - Using Windows or DSVD Application Software; Using the Command Mode of Windows Hyperterminal

Compaq Armada 7800
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using the Internal Modem 7-23
Writer: Carey Gregg Saved by: Rebecca Wiggins Saved date: 02/06/98 11:07 AM
Part Number: 314932-001 File name: Ch07.doc
Using Windows or DSVD Application Software
NOTE:
The following instructions apply when you are using
modem drivers from Windows to communicate with the modem.
If you are using a communications application other than
Windows to initiate a DSVD call, refer to the software
documentation for instructions on manually entering AT
commands.
If you are running Windows:
1
Click Start
Æ
Settings
Æ
Control Panel
Æ
double-click
Modems.
2
Click Properties from the General Tab.
3
Click Advanced from the Connection Tab.
4
In the Extra Settings option, type
AT-SSE=1-SSE-AC-SSE-
FNS0=1
5
Click OK
Æ
OK
Æ
Close to exit.
The command typed above has four parts:
-SSE=1 enables DSVD operation.
-SSE-AC tells the modem to automatically establish a DSVD
session upon connection to another DSVD-enabled modem.
-SSE-FN sets the modem to enable a full-duplex speakerphone
operation after a DSVD connection occurs.
SO=1 sets the modem to answer on the first incoming ring.
Using the Command Mode of Windows HyperTerminal
NOTE:
To locate Windows HyperTerminal, click Start
Æ
Programs
Æ
Accessories
Æ
HyperTerminal.

Table of Contents

Related product manuals