EasyManua.ls Logo

Compaq Armada 7800 - Starting with a Data Connection

Compaq Armada 7800
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using the Internal Modem 7-25
Writer: Carey Gregg Saved by: Rebecca Wiggins Saved date: 02/06/98 11:07 AM
Part Number: 314932-001 File name: Ch07.doc
Starting with a Data Connection
From the command mode of Windows HyperTerminal, follow
these instructions.
To initiate a data call:
1
Type
AT-SSE=1
then press
Enter
to enable DSVD operation.
The modem responds OK.
2
Type
ATDTXXXXXXX
(where X = each digit of the phone
number) then press
Enter
.
The modem is now in data mode and you can enter AT
commands.
3
Escape to Command Mode by typing
Shift
+++
wait for OK.
4
Type
AT+VLS=7;O
then press
Enter
to enable DSVD mode.
NOTE:
When -SSE=1 and speakerphone are active, the D
command causes an automatic change from +FCLASS=8 to
+FCLASS=0.
To answer a data call:
1
Type
AT-SSE=1
then press
Enter
to enable DSVD operation.
The modem responds OK. The modem is now in data mode
and you can enter AT commands.
2
If the modem is ringing, type
ATA
then press
Enter
.
The modem is now in data mode and you can enter AT
commands.
3
Escape to Command Mode by typing
Shif
t+++
then wait for
OK.
4
Type
AT+VLS=7;O
then press
Enter
to enable DSVD mode.
NOTE:
When -SSE=1 and speakerphone are active, the D
command causes an automatic change from +FCLASS=8 to
+FCLASS=0.

Table of Contents

Related product manuals