B-6 Regulatory Notices
Writer: Carey Gregg Saved by: Carey Gregg Saved date: 12/19/97 1:37 PM
Part Number: 314932-001 File name: Appb.doc
A power cord should be routed so that it is not likely to be walked
on or pinched by items placed upon it or against it. Particular
attention should be paid to the plug, electrical outlet, and the point
where the cord exits from the product.
Laser Safety
All Compaq systems equipped with laser products comply with
appropriate safety standards, including IEC 825. With specific
regard to the laser, the equipment complies with laser product
performance standards set by government agencies for Class 1
laser products. It does not emit hazardous light; the beam is totally
enclosed during all modes of customer operation and maintenance.
CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the
U.S. Food and Drug Administration implemented regulations for
laser products on August 2, 1976. These regulations apply to laser
products manufactured from August 1, 1976. Compliance is
mandatory for products marketed in the United States.
!
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein or in the laser
product installation guide may result in hazardous radiation
exposure.
This system is classified as a
Class 1 laser product. This
label appears on the laser
product.
Laser Information
Laser Type: Semiconductor GaAlAs
Wave Length: 780
±
35 nm
Divergence Angle: 53.5
°
±
1.5
°
Output Power: Less than 0.2mW or 10,869 W·m
-2
sr
-1
Polarization: Circular
Numerical Aperture: 0.45
±
0.04
To Next Page
Loading...
