Comtech EF Data DMD1050TS - Page 183

DMD1050TS Satellite Modem Board
Revision 1
Web Browser 7–61 MN-DMD1050TS
Alarms | Common Page
TransecPwrTest • Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
Displays the results of the Power On Self Test (POST)
done by the TRANSEC module when installed.
VOLTAGE
+1.5V RX Supply
•
Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
This shows if the measured voltage of the 1.5 Volt Rx
power bus that is inside the modem is xxx.
-1.5V TX Supply • Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
This shows if the measured voltage of the 1.5 Volt Tx power
bus that is inside the modem is xxx.
+3.3V Supply
•
Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
This shows if the measured voltage of the +3.3 Volt power
bus that is inside the modem is xxx.
+5V Supply
• Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
This shows if the measured voltage of the +5 Volt power
bus that is inside the modem is xxx.
+12V Supply • Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
This shows if the measured voltage of the +12 Volt power
bus that is inside the modem is xxx.
-12V Supply
•
Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
Displays the measured voltage of the -12 Volt power bus
located inside the modem.
+20V Supply
• Current
• Latched
• Masked (checkmark)
• Unmasked (no check)
This shows if the measured voltage of the +20 Volt power
bus that is inside the modem is xxx.
RESET LATCHED
ALARMS
Use to reset (Clear) all Latched Alarms.