223 • DM NAX® Product Manual — Doc. 9045M
Casting
The Casting section is used to enable or disable the ability of third-party devices to cast audio to the
DMNAX output zone, as well as set a maximum casting volume and friendly name for the zone.
To configure Casting:
1. Maximum Casting Volume is an alternate value for the Maximum volume set in the
Minimum/Maximum Volume on page 214 settings, applied to the zone only when a casting service
is routed to it. To set the maximum casting volume, do one of the following:
l
Move the Maximum Casting Volume slider right to increase or left to decrease the
maximum volume.
l
Click the arrows to increase or decrease the maximum casting volume. Values range from
70% to 100%, adjustable in increments of 1%.
l
Manually enter a value in the Maximum Casting Volume field.
NOTE:If the Maximum Casting Volume value is higher than the regular Maximum volume
value, the Maximum value will be applied instead.
2. A custom casting name (for example, "Living Room") must be entered so that a name for the
zone will be displayed in the list of available casting destinations when initiating a stream. Enter
this friendly name in the Casting Name field.
NOTE:Ensure that the Casting Name field is populated as any field with an asterisk (*) is
mandatory.
Once AirPlay® and/or Spotify Connect™ are enabled, this name will be displayed as an available
destination on the casting device.
To Next Page
Loading...
Need help?
General
