Product Manual — Doc. 9045M DM NAX® • 564
5. The Night Mode feature applies subtle processing to restrict the dynamic range of the zone audio,
to allow for lower listening levels at night or in rooms where higher listening levels would be
disruptive. To select a dynamics processing level, select an option from the Night Mode drop-down
menu. The available options are Off, Low, Medium, and High. By default, Off is selected.
Balance
To adjust the left/right balance of the stereo output signal, do one of the following:
l
Move the Balance slider to the right to shift the stereo balance to the right channel or to the left
to shift the balance to the left.
l
Click the arrows to adjust the balance left or right. The up arrow shifts the balance to the right
while the down arrow shifts the balance to the left.
l
Manually enter a value in the Balance field. Values range from -50 to 50, adjustable in increments
of 1. Positive values shift the balance to the right while negative values shift the balance to the
left.
Delay
To set the delay, do one of the following:
l
Move the Delay Time(ms) slider to the right to increase or to the left to decrease the delay time.
l
Click the ms arrows to increase or decrease the delay. Values range from 0ms to 85ms,
adjustable in increments of 1ms.
l
Manually enter a value in the Delay Time(ms) field.
NOTE: The Delay feature is only available on the line level output channels.
Output
Click Output to access the settings for Minimum/Maximum Volume, Stereo/Mono, Signal, Bussing
Volume Offset, Signal Generator, and Equalizer Settings.
To Next Page
Loading...
Need help?
General
