445 • DM NAX® Product Manual — Doc. 9045M
NOTE: This will begin transmitting multicast traffic on your network, refer to the General Network
Requirements document for details.
Zones
The Zones section contains the Volume and Mute settings for all zone outputs of the device, as well as a
Configure option for more advanced settings within each zone.
Give each zone a friendly name using the Name column of the Zones table. If the device is paired with a
control system, these names may be overwritten by the control system's program.
To configure the zone volume, do one of the following:
l
Move the Volume slider to the right to increase or to the left to decrease the zone volume.
l
Click the % arrows to increase or decrease the zone volume. Values range from 0 to 100%,
adjustable in increments of 1%.
l
Manually enter a value in the Volume field.
To mute all audio output from a zone, click its respective Mute button. To unmute the zone, click the
Muted button.
Zone Settings
To configure zone settings, click the Configure button ( ). The Edit Zone window appears.
Zone
Click Zone to access the settings for Tone, Balance, and Delay.
To Next Page
Loading...
Need help?
General
