Product Manual — Doc. 9045M DM NAX® • 422
Control System
1. Click the Encrypt Connection button to navigate to the Security tab to configure encryption
settings.
2. Enter a username in the Control System Username field.
3. Enter a password in the Control System Password field.
4. Enter the Room ID in the Room ID field.
5. Enter the IP IDof the DM-NAX-AMP-X300 in the IP ID field.
6. Enter the IP address or hostname of the control system in the IP Address/Hostname field.
7. Click the Save Changes button to save the new entries. The Control System Save message box
appears, indicating that the control system settings were saved successfully. Click the Revert
button to revert to the previous settings without saving.
Cloud Settings
Set the Cloud Settings toggle to enabled (right) or disabled (left) to specify whether the DM-NAX-AMP-
X300 can communicate with the XiOCloud® platform.
Device Modes
Use the Device Modes section to configure the Application Mode, Audio-Over-IPMode, and Standby
Mode, as well as see a live status readout of the device's rear panel functionality.
To Next Page
Loading...
Need help?
General
