Product Manual — Doc. 9045M DM NAX® • 410
2. Click Yes, Reboot Now to reboot the device. The Reboot message box appears.
Wait for the device reboot to complete before attempting to reconnect to the device.
Restore to Factory Default Settings
1. Click Restore in the Actions drop-down menu to restore the settings of the DM-NAX-AMP-X300
to factory defaults.
NOTE: When settings are restored, all settings, including the network settings, will revert to
the factory default. If a static IP address is set, restoring the device to factory default
settings will revert the IP address to the default DHCP mode.
2. Click Yes in the Confirmation dialog to restore the DM-NAX-AMP-X300 to factory settings. Click
No to cancel the restore operation.
A dialog is displayed again, indicating that the restore process was successful and that the device
rebooted.
You can also restore the device by following the Reset procedures in the DM-NAX-AMP-X300
Installation on page 105 section of this manual.
Update Firmware
1. Click Update Firmware in the Actions drop-down menu.
2. In the Firmware Upgrade dialog, click + Browse.
3. Locate and select the desired firmware file, and then click Open. The selected firmware file name
is displayed in the Firmware Upgrade dialog.
4. Click Load and wait for the progress bar to complete and for the OK button in the message to
become clickable.
5. Click OK. The device with new firmware can now be accessed.
To Next Page
Loading...
Need help?
General
