621 • DM NAX® Product Manual — Doc. 9045M
l
Click the Paired Device Options button to open a Paired Device Options window with a drop-
down menu and a Send button. Select a command from the drop-down menu, then click the Send
button to issue the command to the DMNAX device.
o
Release All Paired Devices will disconnect all currently paired devices from the
DM-NAX-BTIO-1G.
o
Release Inactive Paired Devices will disconnect any paired device that is out of range of the
DM-NAX-BTIO-1G.
o
Forget All Paired Devices will delete all currently paired devices from the Paired Devices
table of the DM-NAX-BTIO-1G.
o
Forget Inactive Paired Devices will delete any paired devices from the Paired Devices table
that are out of range of the DM-NAX-BTIO-1G.
o
Forget Connected Devices will delete any device from the Paired Devices table that has a
Connected status.
l
Pairing Code Enabled is reserved for future use.
l
Set the Connect Chime Enable toggle to the right to hear a short chime audio file whenever a
device successfully pairs to the DM-NAX-BTIO-1G. This chime is played back on the Bluetooth
audio input path. Any outputs that receive the Bluetooth audio input signal will receive the chime
audio. Set the Connect Chime Enable toggle to the left to disable the connect chime.
l
Set the Disconnect Chime Enable toggle to the right to hear a short chime audio file whenever a
device is disconnected from the DM-NAX-BTIO-1G. This chime is played back on the Bluetooth
audio input path. Any outputs that receive the Bluetooth audio input signal will receive the chime
audio. Set the Disconnect Chime Enable toggle to the left to disable the disconnect chime.
Display
The Display section contains settings that affect the front panel OLED display of the DM-NAX-BTIO-1G.
l
To adjust the display brightness:
o
Click the % arrows to increase or decrease the brightness. Values range from 0 to 100%,
adjustable in increments of 1%.
o
Manually enter a percentage value in the Brightness text field.
l
To adjust the display standby timeout:
o
Click the Minutes arrows to increase or decrease the brightness. The default timeout value
is one minute.
o
Manually enter a value in the Standby Timeout text field.
l
Set the Button Lockout toggle to the right to lock out the front panel buttons on the
DM-NAX-BTIO-1G. Set the Button Lockout toggle to the left to disable the lockout.
To Next Page
Loading...
Need help?
General
