Product Manual — Doc. 9045M DM NAX® • 476
Save Changes
Click Save Changes to save any changes made to the configuration settings.
Revert
Click Revert to revert the device back to the last saved configuration settings.
Reboot the DM-NAX-AUD-IO
Certain changes to the settings may require the DM-NAX-AUD-IO to be rebooted to take effect. To
reboot the device, do the following:
1. Click Reboot in the Actions drop-down menu. The Confirmation message box appears.
2. Click Yes, Reboot Now to reboot the device. The Reboot message box appears.
Wait for the device reboot to complete before attempting to reconnect to the device.
Restore to Factory Default Settings
1. Click Restore in the Actions drop-down menu to restore the settings of the DM-NAX-AUD-IO to
factory defaults.
NOTE: When settings are restored, all settings, including the network settings, will revert to
the factory default. If a static IP address is set, restoring the device to factory default
settings will revert the IP address to the default DHCP mode.
2. Click Yes in the Confirmation dialog to restore the DM-NAX-AUD-IO to factory settings. Click No
to cancel the restore operation.
A dialog is displayed again, indicating that the restore process was successful and that the device
rebooted.
To Next Page
Loading...
Need help?
General
