Product Manual — Doc. 9045M DM NAX® • 628
5. Set the Auto Initiation toggle to the right position to enable auto initiation. Set the toggle to the
left position to disable auto initiation.
l
If Auto Initiation is enabled for a given stream, the stream will begin transmitting
automatically and will be available as a multicast stream on your network at the specified
multicast address.
l
If Auto Initiation is disabled for the input, the stream will not begin transmitting until it is
manually initiated.
6. To set the port number, do one of the following:
l
Click the arrows to increase or decrease the port number by increments of 1.
l
Manually enter a port number in the Port field. The default port number for DMNAX
streams is 5004.
7. Click OK to save or click Cancel to cancel the changes.
Configure Receivers
1. Enter the multicast address of a transmitting stream in the Requested Stream Address field to
subscribe the receiver to the stream.
2.
Click the configure button ( ) in the Actions column. The Configure dialog appears:
3. Set the Auto Initiation toggle to the right position to enable auto initiation. Set the toggle to the
left position to disable auto initiation.
l
If Auto Initiation is enabled, the stream will begin automatically when the receiver
subscribes to the transmitter.
l
If Auto Initiation is disabled, the stream will not begin until it is manually initiated.
To Next Page
Loading...
Need help?
General
