46 • DM NAX® Product Manual — Doc. 9045M
Controls and Indicators
PWR (1) LED. White indicates that the device is switched on with audio passing. Red
indicates that the device is in standby mode. Off indicates that there is no power from
the power supply.
LAN (1) LED. White indicates that the device is switched on and has a valid IPaddress. Off
indicates that the device is not connected to a network or the IPaddress is invalid.
NAX (1) LED. White indicates that AoIP is ready to pass and the unit's PTP clock is synced.
Off indicates that no AoIP is passing to or from and/or PTP is not synced.
SOURCE 1-8 (8) LEDs. White indicates signal presence on the specified input/source. Red indicates
there is a clipping on an analog input or a bitstream issue on a digital input. Off
indicates that there is no signal detected on the specified input/source.
ZONE 1-4 (4) LEDs. White indicates there is audio output on the indicated zone. Red indicates
clipping is detected on the output audio.
SETUP (1) LED. Blinking red indicates that a network reset or factory restore has been
initiated via the adjacent SETUP button.
Power
Power Consumption 15.9 W
Environmental
Temperature 32° to 104°F (0° to 40°C)
Humidity 10% to 90% RH (non-condensing)
Heat Dissipation 57 BTU/hr
Construction
Chassis Metal, black and silver finish, vented sides
Mounting 1 RU rack-mountable
Dimensions
Height 1.73 in. (44 mm)
Width 19 in. (482 mm)
17.28 in. (439 mm) without rack ears
Depth 14.50 in. (368 mm)
To Next Page
Loading...
Need help?
General
