CTS FOS-3128 Series - Page 117

117
After completing the VLAN settings for your FOS-3128 switches, you can issue the commands
listed below for checking your configuration
Example 1,
FOS-3128(config)# show vlan interface
Example 2,
FOS-3128(config)# show vlan
========================================================================
IEEE 802.1q Tag VLAN Interface :
========================================================================
Dot1q-Tunnel EtherType : : 0x9100
Port Access-vlan User Priority Port VLAN Mode Trunk-vlan
---- ------------------ ---------------- ----------------------- -----------------------------
1 10 0 dot1q tunnel 1
2 1 0 trunk 10
3 20 0 dot1q tunnel 1
4 20 0 dot1q tunnel 1
5 1 0 access 1
6 1 0 access 1
:
:
:
:
:
:
27 1 0 access 1
28 1 0 access 1
FOS-3128(config)#
========================================================================
IEEE 802.1q VLAN Table :
========================================================================
CPU VLAN ID : 1
Management Priority : 0
U: untagged port, T: tagged port, D: dot1q-tunnel port, V: member port
----------------------------------------------------------------------------------------------------------
VLAN Name VLAN 1 8 9 16 17 24 25 28 CPU
------------------ -------- ------------- ------------------ ------------------ --------- ----
Default_VLAN 1 ----UUUU UUUUUUUU UUUUUUUU UUUU V
VLAN0010 10 DT--------- ----------------- ------------------ --------- --
VLAN0020 20 ----DD---- ----------------- ------------------ --------- --
FOS-3128(config)#