13. Access Control List (ACL) Configuration: Set up access control entries and lists.
14. Layer 2 Protocol Tunneling (L2PT) Configuration: Enable or disable L2PT function and set
up acceptable BPDUs for GBPT (Generic Bridge PDU Tunneling).
15. LLDP Configuration: Enable or disable LLDP on ports and set up LLDP-related attributes.
16. Loop Detection Configuration: Enable or disable Loop Detection function and set up Loop
Detection configuration.
4.4.1 Switch Configuration
Click the option Switch Configuration from the Switch Management menu and then the
following screen page appears.
Maximum Frame Size: Specify the maximum frame size between 1518 and 9600 bytes. The
default maximum frame size is 9600bytes.
MAC Address Aging Time: Specify MAC Address aging time between 0 and 172800 seconds.
“0” means that MAC addresses will never age out.
Statistics Polling Port: Specify the number of ports for data acquisition at a time.
Statistics Polling Interval: Specify the time interval in 1/10 seconds for data acquisition.
For more details on the data statistics, you may refer to Section 4.5.4, 4.5.5 and 4.5.6 in this
manual.
To Next Page
Loading...
