4.6.5 Load Factory Settings
Load Factory Setting will set all the configurations of the Managed Switch back to the factory
default settings, including the IP and Gateway address. Load Factory Setting is useful when
network administrators would like to re-configure the system. A system reset is required to make
all changes effective after Load Factory Setting.
Select Load Factory Setting from the System Utility menu and then the following screen page
appears.
Click OK to start loading factory settings.
4.6.6 Load Factory Settings Except Network Configuration
Load Factory Settings Except Network Configuration will set all the configurations of the
Managed Switch back to the factory default settings. However, IP and Gateway addresses will not
restore to the factory default. It is very useful when network administrators need to re-configure the
system “REMOTELY” because conventional Factory Reset will bring network settings back to
default and lose all network connections.
Select Load Factory Setting Except Network Configuration from the System Utility menu, the
following screen page shows up.
Click OK to start loading factory settings except network configuration.
To Next Page
Loading...
Need help?
General
