2.6.14 Management Command
Switch(config)# management
console
Enable Console management. To manage
the Managed Switch via Console.
Switch(config)# management
console fail-retry [1-10]
Configure the retry times if the console
login fails. The allowable value is 1~10
(times).
Switch(config)# management
console block-time [1-120]
Configure the coslole block time of the
Managed Switch if the console login retry
times are more than the console fail-retry
value you set up. The allowable value 1-
120 (minutes).
Switch(config)# management
console timeout [1-1440]
To disconnect the Managed Switch when
console management is inactive for a
certain period of time. The allowable value
is from 1 to 1440 (seconds).
Switch(config)# management
console timeout [1-1440] min
To disconnect the Managed Switch when
console management is inactive for a
certain period of time. The allowable value
is from 1 to 1440 (minutes).
Switch(config)# management
ssh
Enable SSH management. To manage the
Managed Switch via SSH.
Switch(config)# management
telnet
Enable Telnet Management. To manage
the Managed Switch via Telnet.
Switch(config)# management
telnet port [1-65535]
When telnet is enabled, you can set up the
port number that allows telnet access.
The default port number is set to 23.
However, you can also identify a port
number between 1 and 65535.
Switch(config)# management
web
Enable Web Management. To manage the
Managed Switch via Web management.
Switch(config)# management
web timeout [1-1440]
To disconnect the Managed Switch when
web management is inactive for a certain
period of time. The allowable value is from
1 to 1440(minutes).
Switch(config)# no management
console
Disable Console management.
Switch(config)# no management
console fail-retry
Reset console fail-retry times back to the
default (3 times).
Switch(config)# no management
console block-time
Reset console block-time back to the
default (20 minutes).
Switch(config)# no management
console timeout
Reset console timeout back to the default
(300 seconds).
Switch(config)# no management
ssh
Switch(config)# no management
telnet
Disable Telnet management.