CTS FOS-3128 Series - 2.6.17 QoS Configuration

69
2.6.17 QoS Command
1. Set up Qos
QoS command
Parameter
Description
Switch(config)# qos [802.1p | dscp]
[802.1p | dscp]
Specify QoS mode.
Switch(config)# qos dscp-map [0-
63] [0-7]
[0-63]
Specify a DSCP bit value.
[0-7]
Specify a queue value.
Switch(config)# qos management-
priority [0-7]
[0-7]
Specify management default
802.1p bit.
Switch(config)# qos queuing-mode
[weight]
[weight]
Specify QoS queuing mode as
weight mode.
Switch(config)# qos queue-
weighted [1:2:4:8:16:32:64:128]
[1:2:4:8:16:32:64
:128]
Specify the queue weighted.
Switch(config)# qos remarking dscp
Globally enable DSCP bit
remarking.
Switch(config)# qos remarking
dscp-map [1-8]
[1-8]
Specify the DSCP and priority
mapping ID.
Switch (config-dscp-map-ID)# new-
dscp [0-63]
[0-63]
Specify the new DSCP bit value
for the selected priority mapping
ID.
Switch (config-dscp-map-ID)# rx-
dscp [0-63]
[0-63]
Specify the received DSCP bit
value for the selected priority
mapping ID.
Switch(config)# qos remarking
802.1p
Globally enable 802.1p bit
remarking.
Switch(config)# qos remarking
802.1p-map [1-8]
[1-8]
Specify the 802.1p and priority
mapping ID.
Switch (config-802.1p-map-ID)#
priority [0-7]
[0-7]
Specify the new 802.1p bit value
for the selected priority mapping
ID.
Switch(config)# qos 802.1p-map [0-
7] [0-7]
[0-7]
Specify an 802.1p bit value.
[0-7]
Specify a queue value.
No command
Switch(config)# no qos
Disable QoS function.
Switch(config)# no qos dscp-map
[0-63]
[0-63]
Reset the specified DSCP bit
value back to the default queue
value (Q(0)).
Switch(config)# no qos
management-priority
Reset management 802.1p bit
back to the default (0).
Switch(config)# no qos queuing-
mode
Specify QoS queuing mode as
strict mode.
Switch(config)# no qos queue-
weighted
Reset the queue weighted value
back to the default.
Switch(config)# no qos remarking
dscp
Globally disable DSCP bit
remarking.
Switch(config)# no qos remarking
dscp-map [1-8]
[1-8]
Reset the DSCP remaking for
the specified priority mapping ID