CTS FOS-3128 Series - Page 70

70
back to the default.
Switch (config-dscp-map-ID)# no
new-dscp
Reset the new DSCP bit value
for the selected priority mapping
ID back to the default.
Switch (config-dscp-map-ID)# no rx-
dscp
Reset the received DSCP bit
value for the selected priority
mapping ID back to the default.
Switch(config)# no qos remarking
802.1p
Globally disable 802.1p bit
remarking.
Switch(config)# no qos remarking
802.1p-map [1-8]
[1-8]
Reset the 802.1p remaking for
the specified priority mapping ID
back to the default.
Switch (config-802.1p-map-ID)# no
priority
Reset the new 802.1p bit value
for the selected priority mapping
ID back to the default.
Switch(config)# no qos 802.1p-map
[0-7]
[0-7]
Reset the specified 802.1p bit
value back to the default queue
value (Q(0)).
Show command
Switch(config)# show qos
Show QoS configuration.
Switch(config)# show qos interface
Show QoS interface overall
information.
Switch(config)# show qos interface
[port-list]
[port-list]
Show the selected QoS interface
information.
Switch(config)# show qos remarking
Show QoS remarking
information.
Switch (config-dscp-map-ID)# show
Show the DSCP mapping
configuration for the selected
priority mapping ID.
Switch (config-802.1p-map-ID)#
show
Show the 802.1p mapping
configuration for the selected
priority mapping ID.
2. Use “interface” command to configure a group of ports’ QoS settings.
QoS & Interface command
Parameter
Description
Switch(config)# interface [port_list]
[port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)#
qos rate-limit ingress [0,500-
1000000]
[0,500-
1000000]
kbps
Specify the ingress rate limit value.
0:Disable
Switch(config-if-PORT-PORT)#
qos rate-limit egress [0,500-
1000000]
[0,500-
1000000]
kbps
Specify the egress rate limit value.
0:Disable
Switch(config-if-PORT-PORT)#
qos user-priority [0-7]
[0-7]
Specify the default priority bit to the
selected interfaces.