4.3 Network Management
In order to enable network management of the Managed Switch, proper network configuration is
required. To do this, click the folder Network Management from the Main Menu and then the
following screen page appears.
1. Network Configuration: Set up the required IP configuration of the Managed Switch.
2. System Service Configuration: Enable or disable the specified network services.
3. RS232/Telnet/Console Configuration: View the RS-232 serial port setting, specific Telnet
and Console services.
4. Time Server Configuration: Set up the time server’s configuration.
5. Device Community: View the registered SNMP community name list. Add a new community
name or remove an existing community name.
6. Trap Destination: View the registered SNMP trap destination list. Add a new trap destination
or remove an existing trap destination.
7. Trap Configuration: View the Managed Switch trap configuration. Enable or disable a specific
trap.
8. Syslog Configuration: Set up the Mal-attempt Log server’s configuration.
To Next Page
Loading...
Need help?
General
