D-Link xStack DGS-3620 Series - Page 100

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
95
timeout - (Optional) Specifies the time in second to wait for the server to reply.
<int 1-255> - Enter the value between 1 and 255. The default value is 5.
retransmit - (Optional) Specifies the count for re-transmissions.
<int 1-20> - Enter the value between 1 and 20. The default value is 2.
Restrictions
Only Administrator level can issue this command.
Example
To configure the TACACS server host:
DGS-3620-28PC:admin#config tacacs server_host 10.1.1.223 retransmit 5
Command: config tacacs server_host 10.1.1.223 retransmit 5
Key is meaningless for TACACS and XTACACS.
Success.
DGS-3620-28PC:admin#
4-51 create tacacs+ server_host
Description
This command is used to create a TACACS+ server host.
Format
create tacacs+ server_host <ipaddr> {port <int 1-65535> | [key [<key_string 254> | none] |
encryption_key <key_string 344>] | timeout <int 1-255>}
Parameters
<ipaddr> - Enter the IP address of the server host.
port - (Optional) The port number of the TACACS+ server host.
<int 1-65535> - Enter the value between 1 and 65535. The default value is 49.
key - (Optional) Specifies the key for TACACS+.
<key_string 254> - Enter the plain text key string for TACACS+.
none - No encryption for RADIUS.
encryption_key - (Optional) The encrypted form key string for TACACS+. The encryption
algorithm is based on DES.
<key_string 344> - Etner the string with maximum 344 characters.
timeout - (Optional) Specifies the time in second to wait for the server to reply.
<int 1-255> - Enter the value between 1 and 255. The default value is 5.
Restrictions
Only Administrator level can issue this command.
Example
To create a TACACS+ server host: