D-Link xStack DGS-3620 Series - Page 102

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
97
Format
create xtacacs server_host <ipaddr> {port <int 1-65535> | timeout <int 1-255> | retransmit
<int 1-20>}
Parameters
<ipaddr> - Enter the IP address of the server host.
port - (Optional) The port number of the XTACACS server host.
<int 1-65535> - Enter the value between 1 and 65535. The default value is 49.
timeout - (Optional) Specifies the time in second to wait for the server to reply.
<int 1-255> - Enter the value between 1 and 255. The default value is 5.
retransmit - (Optional) Specifies the count for re-transmissions.
<int 1-20> - Enter the value between 1 and 20. The default value is 2.
Restrictions
Only Administrator level can issue this command.
Example
To create a XTACACS server host:
DGS-3620-28PC:admin#create xtacacs server_host 10.1.1.224 port 15555 timeout 10
Command: create xtacacs server_host 10.1.1.224 port 15555 timeout 10
Success.
DGS-3620-28PC:admin#
4-54 config xtacacs server_host
Description
This command is used to configure a XTACACS server host.
Format
config xtacacs server_host <ipaddr> {port <int 1-65535> | timeout <int 1-255> | retransmit
<int 1-20>}
Parameters
<ipaddr> - Enter the IP address of the server host.
port - (Optional) The port number of the XTACACS server host.
<int 1-65535> - Enter the value between 1 and 65535. The default value is 49.
timeout - (Optional) Specifies the time in second to wait for the server to reply.
<int 1-255> - Enter the value between 1 and 255. The default value is 5.
retransmit - (Optional) Specifies the count for re-transmissions.
<int 1-20> - Enter the value between 1 and 20. The default value is 2.