D-Link xStack DGS-3620 Series - Page 1046

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1041
<value 1-100> - Enter the percentage rate value here. This value must be between 1 and 100
percent.
max_rate - Specifies one of the parameters below will be applied to the maximum rate that the
class specified above will be allowed to transmit packets at.
no_limit - Indicates there is no limit on egress queue of specified port bandwidth.
<value 8-10240000> - Enter an integer value from 8 to 10240000 to set a maximum limit in
Kbits/sec. The specified bandwidth limit may be equaled but not exceeded. The exact
logical limit or token value is hardware determined.
percent – Specifies the maximum percentage rate value.
<value 1-100> - Enter the percentage rate value here. This value must be between 1 and 100
percent.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the maximum rate to be 100 on queue 1 for ports 1 to 10:
DGS-3620-28PC:admin#config per_queue bandwidth_control ports 1:1-1:10 1
max_rate 100
Command: config per_queue bandwidth_control ports 1:1-1:10 1 max_rate 100
Granularity: TX: 8. Actual Rate: MAX: 96.
Success.
DGS-3620-28PC:admin#
91-4 show per_queue bandwidth_control
Description
This command is used to display the bandwidth control setting of per egress queue for each port.
Format
show per_queue bandwidth_control {<portlist>}
Parameters
<portlist> - (Optional) Specifies a range of ports to be displayed.
Restrictions
None
Example
To display the port bandwidth control table for port 1:
DGS-3620-28PC:admin#show per_queue bandwidth_control 1
Command: show per_queue bandwidth_control 1