EasyManuals Logo

D-Link xStack DGS-3620 Series User Manual

D-Link xStack DGS-3620 Series
1371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1045 background imageLoading...
Page #1045 background image
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1040
Restrictions
None.
Example
To display the port bandwidth control table for ports 1 to 2:
DGS-3620-28PC:admin#show bandwidth_control 1-2
Command: show bandwidth_control 1-2
Bandwidth Control Table
Port RX Rate TX Rate Effective RX Effective TX
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
---- ---------- ---------- ---------------- ----------------
1 No Limit No Limit No Limit No Limit
2 No Limit No Limit No Limit No Limit
DGS-3620-28PC:admin#
91-3 config per_queue bandwidth_control
Description
This command is used to set the bandwidth control for each specific egress queue on specified
ports. The maximum rate limits the bandwidth. When specified, packets transmitted from the
queue will not exceed the specified limit even if extra bandwidth is available. The specification of
maximum rate is effective regardless of whether the queue is operating in strict or Shaped Deficit
Weighted Round Robin (SDWRR) mode.
Format
config per_queue bandwidth_control {ports [<portlist> | all]} <cos_id_list> {{min_rate
[no_limit | <value 8-10240000> | percent <value 1-100>]} max_rate [no_limit | <value 8-
10240000> | percent <value 1-100>]}
Parameters
ports - (Optional) Specifies a range of ports to be configured.
<portlist> - Enter a range of ports to be configured.
all - Specifies to set all ports in the system. If no parameter is specified, the system will set all
the ports.
<cos_id_list> - Enter a list of priority queues.
min_rate - Specifies that one of the parameters below will be applied to the minimum rate that
the class specified above will be allowed to transmit packets at.
no_limit - Indicates there is no limit on egress queue of specified port bandwidth.
<value 8-10240000> - Enter an integer value from 8 to 10240000 to set a minimum limit in
Kbits/sec. The specified bandwidth limit may be equaled but not exceeded. The exact
logical limit or token value is hardware determined.
percent – Specifies the minimum percentage rate value.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link xStack DGS-3620 Series and is the answer not in the manual?

D-Link xStack DGS-3620 Series Specifications

General IconGeneral
BrandD-Link
ModelxStack DGS-3620 Series
CategorySwitch
LanguageEnglish

Related product manuals