D-Link xStack DGS-3620 Series - Page 1053

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1048
Priority-3 -> <Class-3>
Priority-4 -> <Class-4>
Priority-5 -> <Class-5>
Priority-6 -> <Class-6>
Priority-7 -> <Class-7>
Port 2
Priority-0 -> <Class-2>
Priority-1 -> <Class-0>
Priority-2 -> <Class-1>
Priority-3 -> <Class-3>
Priority-4 -> <Class-4>
Priority-5 -> <Class-5>
Priority-6 -> <Class-6>
Priority-7 -> <Class-7>
DGS-3620-28PC:admin#
91-11 config 802.1p default_priority
Description
This command is used to specify default priority for untagged packets received on a port of the
switch.
Format
config 802.1p default_priority [<portlist> | all ] <priority 0-7>
Parameters
<portlist> - Enter a range of ports for which the default priority is to be configured. That is, a
range of ports for which all untagged packets received will be assigned the priority specified
below. The beginning and end of the port list range are separated by a dash.
all - Specifies that the command applies to all ports on the switch.
<priority 0-7> - Enter a priority value (0 to 7) to assign to untagged packets received by the
switch or a range of ports on the switch.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure an 802.1p default priority settings of 5 on all Switch ports:
DGS-3620-28PC:admin#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DGS-3620-28PC:admin#