D-Link xStack DGS-3620 Series - Page 1052

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1047
all - Specifies that all the ports will be used for this configuration.
<priority 0-7> - Enter the 802.1p user priority to associate with the <class_id> (the number of the
hardware queue).
<class_id 0-7> - Enter the number of the switch’s hardware priority queue. The switch has eight
hardware priority queues available. They are numbered between 0 (the lowest priority) and 7
(the highest priority).
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure an 802.1p user priority of 1 map to class ID of 3:
DGS-3620-28PC:admin#config 802.1p user_priority 1 3
Command: config 802.1p user_priority 1 3
Success.
DGS-3620-28PC:admin#
91-10 show 802.1p user_priority
Description
This command is used to display 802.1p user priority.
Format
show 802.1p user_priority {<portlist>}
Parameters
<portlist> - (Optional) Specifies the range of ports to be configured.
Restrictions
None.
Example
To display the 802.1p user priority:
DGS-3620-28PC:admin#show 802.1p user_priority
Command: show 802.1p user_priority
QoS Class of Traffic
Port 1
Priority-0 -> <Class-2>
Priority-1 -> <Class-0>
Priority-2 -> <Class-1>