D-Link xStack DGS-3620 Series - Page 1084

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1079
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To disable RIPng globally:
DGS-3620-28PC:admin# disable ripng
Command: disable ripng
Success.
DGS-3620-28PC:admin#
95-3 show ripng
Description
This command is used to display the RIPng state on all or specified interfaces.
Format
show ripng {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the RIPng IP interface name to be displayed.
<ipif_name 12> - Enter the RIPng IP interface name to be displayed here. This name can be
up to 12 characters long.
Restrictions
None. (EI Mode Only Command)
Example
To display RIPng configurations: