D-Link xStack DGS-3620 Series - Page 1085

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1080
DGS-3620-28PC:admin# show ripng
Command: show ripng
Global State: Enabled
Method: Split Horizon
Update Time: 30 seconds
Expire Time: 180 seconds
Garbage Collection Time: 120 seconds
Interface State Metric
-----------------------------------------------------
System Disabled 15
i15 Enabled 1
i30 Enabled 1
i100 Disabled 1
Total Entries : 4
IPv6 Route Redistribution Settings
Source Destination Type Metric
Protocol Protocol
-------- ------------ -------- ------------
Total Entries: 0
DGS-3620-28PC:admin#
95-4 config ripng
Description
This command is used to configure the RIPng algorithm and timer.
Format
config ripng {method [no_horizon | split_horizon | poison_reverse] | update <sec 5-65535> |
expire <sec 1-65535> | garbage_collection <sec 1-65535>} (1)
Parameters
method - (Optional) Specifies the method used.
no_horizon - Specifies to configure not use any horizon.
split_horizon - Specifies to configure use a basic split horizon.
poison_reverse - Specifies to configure to use a split horizon with poison reverse.
update - (Optional) Specifies the value of the update timer.
<sec 5-65535> - Enter the update timer value used here. This value must be between 5 and
65535 seconds.
expire - (Optional) Specifies the interval when the update expires.
<sec 1-65535> - Enter the expire value used here. This value must be between 1 and 65535
seconds.
garbage_collection - (Optional) Specifies the value of the garbage-collection timer.
<sec 1-65535> - Enter the garbage-collection timer value used here. This value must be