D-Link xStack DGS-3620 Series - Page 1115

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1110
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To display sFlow sampler information for the ports that have been created:
DGS-3620-28PC:admin#show sflow flow_sampler
Command: show sflow flow_sampler
Port Analyzer Configured Configured Active Active Max Header
Server ID Rx Rate Tx Rate Rx Rate Tx Rate Size
------ --------- ---------- ---------- ------- ------- -----------
1:15 1 10 10 10 10 18
1:21 1 10 10 10 10 18
Total Entries: 2
DGS-3620-28PC:admin#
100-12 create sflow counter_poller ports
Description
This command is used to create the sFlow counter poller. With the poller function, the statistics
counter information with respect to a port will be forwarded to the server at the configured interval.
These counters are RFC 2233 counters.
Format
create sflow counter_poller ports [<portlist> | all] analyzer_server_id <value 1-4> {interval
[disable | <sec 20-120>]}
Parameters
<portlist> - Enter the ports to be configured.
all - Specifies to configure all ports.
analyzer_server_id - Specifies the ID of an analyzer server where the packet will be forwarded.
<value 1-4> - Enter the ID of an analyzer server where the packet will be forwarded.
interval - (Optional) Specifies the maximum number of seconds between successive statistic
counters information. If set to disable, the counter-poller is disabled. If the interval is not
specified, its default value is disable.
disable - Specifies to disable the interval.
<sec 20-120> - Enter the interval, in seconds, between 20 and 120.
Restrictions
Only Administrators and Operators can issue this command.
Example
To create the sFlow counter poller:
DGS-3620-28PC:admin#create sflow counter_poller ports 1 analyzer_server_id 1