D-Link xStack DGS-3620 Series - Page 1123

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1118
DGS-3620-28PC:admin#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK !!!
SIM Config Success !!!
Success.
DGS-3620-28PC:admin#
To delete a member:
DGS-3620-28PC:admin#config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK !!!
SIM Config Success !!!
Success.
DGS-3620-28PC:admin#
101-6 config sim
Description
This command is used to configure the role state and parameters of discovery protocol on the
switch.
Format
config sim [[commander {group_name <groupname 64>} | candidate] | dp_interval <sec 30-
90> | hold_time <sec 100-255>]
Parameters
commander - Transfer the role to commander.
group_name - (Optional) If commander, users can specify the name of the group.
<groupname 64> - If commander, users can specify the name of the group. The maximum
length is 64 characters.
candidate - Transfer role to candidate.
dp_interval - Specifies the time in seconds between discoveries.
<sec 30-90> - Enter the time in seconds between discoveries.
hold_time - Specifies the time in seconds the device holds the discovery result.
<sec 100-255> - Enter the time in seconds the device holds the discovery result.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.