xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1202
111-5 config surveillance_vlan ports
Description
This command is used to configure the surveillance VLAN state on the specific ports.
Format
config surveillance_vlan ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter a list of ports to be configured.
all - Specifies all ports to be configured.
state - The state of the surveillance VLAN function on the specified ports.
enable - Specifies to enable surveillance VLAN function on the specified ports.
disable - Specifies to disable surveillance VLAN function on the specified ports.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure Surveillance VLAN to the enabled state on ports 4-6 of unit 1:
DGS-3620-28PC:admin#config surveillance_vlan ports 1:4-1:6 state enable
Command: config surveillance_vlan ports 1:4-1:6 state enable
Success.
111-6 config surveillance_vlan aging_time
Description
This command is used to set the aging time of the surveillance VLAN. The aging time is used to
remove a port from the surveillance VLAN if the port is an automatic surveillance VLAN member.
When the last surveillance device stops sending traffic and the MAC address of this surveillance
device is aged out, the surveillance VLAN aging timer will be started. The port will be removed
from the surveillance VLAN after expiration of surveillance VLAN aging timer. If the surveillance
traffic resumes during the aging time, the aging timer will be reset and stopped.
Format
config surveillance_vlan aging_time <min 1-65535>
Parameters
<min 1-65535> - Specifies the aging time. The range is from 1 to 65535 minutes. The default
value is 720.
To Next Page
Loading...
Need help?
General