xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1250
Format
ping [<ipaddr> | <domain_name 255>] {times <value 1-255> | timeout <sec 1-99> | source_ip
<ipaddr>}
Parameters
<ipaddr> - Specifies the IP address of the host.
<domain_name 255> - Specifies the domain name of the host. This name can be up to 255
times – (Optional) Specifies the number of individual ICMP echo messages to be sent.
<value 1-255> - Enter the number of individual ICMP echo messages to be sent. A value of 0
will send an infinite ICMP echo messages. The maximum value is 255. The default is 0
timeout – (Optional) Specifies the time-out period while waiting for a response from the remote
device. A value of 1 to 99 seconds can be specified. The default is 1 second.
<sec 1-99> - Enter the time-out period while waiting for a response from the remote device. A
value of 1 to 99 seconds can be specified. The default is 1 second.
source_ip - Specifies the source IP address of the ping packets. If specified, the IP address will
be used as the packets’ source IP address that ping send to remote host.
<ipaddr> - Enter the source IP addres used here.
Restrictions
None.
Example
To send ICMP echo message to “10.51.17.1” for 4 times:
DGS-3620-28PC:admin#ping 10.51.17.1 times 4
Command: ping 10.51.17.1 times 4
Reply from 10.51.17.1, time<10ms
Reply from 10.51.17.1, time<10ms
Reply from 10.51.17.1, time<10ms
Reply from 10.51.17.1, time<10ms
Ping Statistics for 10.51.17.1
Packets: Sent =4, Received =4, Lost =0
119-17 ping6
Description
This command is used to send Internet Control Message Protocol (ICMP) echo messages to a
remote IPv6 address. The remote IPv6 address will then “echo” or return the message. This is
used to confirm connectivity between the switch and the remote device.
To Next Page
Loading...
Need help?
General