D-Link xStack DGS-3620 Series - Page 1259

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1254
Trace complete.
DGS-3620-28PC:admin#
119-20 telnet
Description
This command is used to login a Telnet server.
Format
telnet [<ipaddr> | <domain_name 255> | <ipv6addr>] {tcp_port <value 1-65535>}
Parameters
<ipaddr> - Enter the IP address of the Telnet server.
<domain_name 255> - Enter the domain name of the telnet server.
<ipv6addr> - Enter the IPv6 address of the Telnet server.
tcp_port - (Optional) Specifies the Telnet server port number to be connected to. If not specified,
the default port is 23.
<value 1-65535> - Enter a value between 1 and 65535.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To Telnet to a switch by specifying the IP address:
DGS-3620-28PC:admin#telnet 10.1.1.1
Command: telnet 10.1.1.1
DGS-3620-28PC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 3.00.004
Copyright(C) 2013 D-Link Corporation. All rights reserved.
UserName:
119-21 enable broadcast_ping_reply
Description
The enable broadcast_ping_reply command used to enable broadcast ping reply state, device will
reply broadcast ping request.