xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
123
DGS-3620-28PC:admin#enable cpu_interface_filtering
Command: enable cpu_interface_filtering
Success.
5-13 disable cpu_interface_filtering
Description
This command is used to disable CPU interface filtering.
Format
disable cpu_interface_filtering
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable CPU interface filtering:
DGS-3620-28PC:admin#disable cpu_interface_filtering
Command: disable cpu_interface_filtering
Success.
5-14 config flow_meter
Description
This command is used to configure the flow-based metering function. The metering function
supports three modes: single rate two color, single rate three color, and two rate three color. The
access rule must be created before the parameters of this function can be applied. For the single
rate two color mode, users may set the preferred bandwidth for this rule, in Kbps, and once the
bandwidth has been exceeded, overflowing packets will either be dropped or remarked DSCP,
depending on the user configuration. For single rate three color mode, users need to specify the
committed rate, in Kbps, the committed burst size, and the excess burst size. For the two rate
three color mode, users need to specify the committed rate in Kbps, the committed burst size, the
peak rate and the peak burst size. The green color packet will be treated as the conforming action,
the yellow color packet will be treated as the exceeding action, and the red color packet will be
treated as the violating action.
To Next Page
Loading...
Need help?
General